View Single Post
Old 15-08-15, 23:11   #361
VL_JOHN
Player
 
VL_JOHN's Avatar
 
Join Date: 07-03-04
Location: Adelaide, Somewhere over the rainbow....
Car: Maranello Red LW5 MX7 BT1
Trader Rating: (0)
Send a message via ICQ to VL_JOHN Send a message via MSN to VL_JOHN
Do this. It is from page one on this thread...

Cut the head from the adjustable bolt you just removed and put a small slit into the end of it with a hack saw, so you can use a straight blade screwdriver to screw it back into the pushrod on the booster.

Note: You must cut the head of the adjustable bolt short enough so it can become level with the pushrod on the booster.



Step 3.

Screw the bolt back into the pushrod and use locktite to lock the thread on it.

Note: Make sure its 100% level with the pushrod itself. The only reason we screw the bolt back into the pushrod is to stop the hollow push rod from collapsing, it may fatigue over time from it being hollow. The bolt will strengthen it. So please don't just leave it out.
VL_JOHN is offline   Reply With Quote