View Single Post
Old 07-06-06, 18:37   #26
MADNESS
Player
 
MADNESS's Avatar
 
Join Date: 19-06-02
Location: Brisbane, South Side
Car: Yours!
Trader Rating: (0)
thanks everyone for the help and advice i havent yet filled up the trans fluid but i finaly fixed the clutch master problem today
turns out the shaft was a few mm to short and wasent engaugeing properly so i got a nut with a built in washer and slid that onto the shaft to give me about 7 mm more clearance fits perfict anbd the car is allmost scary to drive again

few hints for people doing this conversion

get a rubber mallet and and hammer the walls for a easyer fit for the trans installation

get a good clutch tool or a manual input shaft will make the job a hole lot easyer

when puting greese on the inputshaft dont put to much on i did and my clutch sliped a bit but seems fine after a bit of a boosting :P
MADNESS is offline   Reply With Quote