View Single Post
Old 12-07-06, 17:56   #42
ven33m
Player
 
ven33m's Avatar
 
Join Date: 11-07-06
Location: NSW, Forster
Car: VL
Trader Rating: (0)
Send a message via MSN to ven33m
correct procedure

Quote:
Originally Posted by YOGI05
I didn't join the wires at the relay, i joined a light green with black stripe to a pink wire that were both on one of the plugs that were disconected from the auto tranny,this was above the brake master cyclinder.THIS IS FOR THE NEUTRAL POSITION SWITCH.
This is the correct way. Changing the computer or removing it will have no effect on the running of the car.
Also, manual and auto pedal boxes are identical it's just the pedals that need changing.
Auto Spigot bush is removed by carefully drilling small hole on either side. Don't drill too far and drill the crankshaft. than with a cold chisel and hammer carefully callapse it without damaging the crankshaft or seal.
ven33m is offline   Reply With Quote