![]() |
#1 |
Player
|
Roller Lifters for Walky
Anyone who has tried to put a roller cam in their holden V8 will know its not too easy unless you use the right lifters. Walkinshaws are even harder because they have Chrysler lifter bores. I can now get mechanical roller lifter kits to suit the walky which
1. Have the Chrysler (.904") lifter diameter 2. Have a unique design to prevent oil gallery exposure at full lift (no bearing oil loss issues) 3. Have holden tie bars. These took ages to find and make it so much easier to put a roller cam in. If anyone wants a set reply or PM me cause I am ordering them asap. Price is $820 plus freight.
__________________
It is better to keep your mouth shut and appear stupid than to open it and remove all doubt |
![]() |
![]() |
#2 | |
Player
|
Were can I get these roller lifters
Quote:
were can i get these lifters as im in the middle of a rebuild for my walki i was lukey enough to get an unsed block and harrop crank forged pistons sow on Last edited by stevhsv; 06-06-06 at 20:41. Reason: Automerged Doublepost |
|
![]() |
Thread Tools | |
|
|
|
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Changing lifters | natho | Technical Articles | 56 | 10-09-16 06:07 |
FS: Holden V8 Crane H286 Cam and Anti Pump-up Lifters | VL383 | For Sale - Drivetrain | 5 | 10-03-05 07:48 |
About to replace the lifters | Digamma | Engines, Turbos, Exhausts, Intercoolers | 0 | 05-03-05 15:55 |
Lifters, does this seem expensive? | -LBZ- | Engines, Turbos, Exhausts, Intercoolers | 4 | 14-05-04 23:08 |
Lifters, does this seem expensive? | -LBZ- | VL Turbo Discussion | 3 | 13-05-04 18:57 |